EverFocus EDSR400H Instruction Manual download pdf (Page 10)

EVERFOCUS ELECTRONICS CORPORATION

MONITOR

MAIN MONITOR:

his connector is used for the Main monitor display, a number of

different display modes may be selected for viewing. This output

must be used to display the menu settings.

( Internal circuit )

CALL MONITOR:

MAIN

MONITOR

MONITOR OUT

INTERNAL

VIDEO

SW3

hen the machine is in Menu, Search or Copy mode, the internal Video is switched to Monitor Out, so that the user can view

full screen OSD. In other modes, the Video from multiplexer main monitor will be loop-through to the Monitor Out.

his connector is used for the Call (secondary) monitor.

This monitor can only display full screen pictures.

VIDEO IN (1~4):

he BNC connectors of video input enable the system to receive the

signals from each camera through the 75 ohm coaxial cables.

VIDEO OUT (1~4): Sends the signals from each camera to other external devices

(loop out).

VIDEO In/Output

ALARM-OUTPUT: Normal Close Alarm output. In normal condition, this terminal is

shorted to the terminal of ALARM-COM. In alarm status, it is

open between ALARM-NC and ALARM-COM terminals.

ALARM-INPUT: Normal Open or Normal Close type alarm sensor input. The Alarm Input

can be selected as Normal Open or Normal Close input in the setup menu.

When an alarm occurs, alarm recording will automatically start.

larm Input

LAN Connector:

he RJ-45 LAN connector used to connect to a local area

network.

larm Input/ Output

LAN

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 108 109

No comments

EverFocus EDSR400H Instruction Manual Page 10