EverFocus eDR400 Instruction Manual download pdf (Page 7)

EDSR PTZ setup.

Once the data cables are connected, the EDSR recorder is configured to communicate with PTZ camera or cameras.

Please Note: you need to determine what Protocol and Baud Rate is used for the cameras. (Note: All cameras connecting to the

same DVR MUST be on the same Protocol and Baud Rate.)

SETTINGS:

1.) Access the Setup menu by pressing [MENU]

on the front of the unit.

2.) Use the Jog Wheel to highlight the PTZ menu.

Press[ENTER]

3.) In PTZ SETTINGS sub-menu, use [ENTER]

to navigate between the options and the JOG

WHEEL to change the settings.

4.) Set PTZ ENABLE: to ON,

5.) Set the PTZ port to RS485

6.) *Set the PROTOCOL to that of the Cameras

(Pelco-D, Pelco-P, Everfocus, or VProtect)

7.) *Set the BAUD RATE to match that of the

cameras

8.) Under PTZ ADDRESS, enter the Address for

that camera on that specific channel. (Example:

Channel 2 has a camera with Address 1, then

for CH2: the value is change to 001, so it reads

[CH2: 001].)

9.) Press [ENTER] twice to exit out of the setup menus. Restart the system.

*Note: These settings MUST match all the cameras connected on the same circuit.

1 2 3 4 5 6 7 8 9 10 11 12 ... 111 112

No comments

EverFocus eDR400 Instruction Manual Page 7