EverFocus RS232 User Manual download pdf (Page 6)

Installing the Door

Module into the Controller

In this chapter, we will introduce how to mount the door module into an EverAccess

Flex Series controller. The definitions for the reader/door index is also explained.

The EverAccess Flex series controller can accommodates up to 4 door modules and

1 alarm module. The door modules are connected from right to left, with each new

module connecting easily in a cascading fashion. The door modules and the alarm

module can be placed in any sequence. The index will follow the same rules (refer to

next subsection).

The steps to install a door module are described below:

Figure 2.1 Install a door Module to Controller

1. Connect the pins on the lower right corner of the new module to the connector

on the bottom left corner of the installed module. Make sure that the pins fit

snugly into the receiving module.

Chapte

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

No comments

EverFocus RS232 User Manual Page 6