EverFocus eDR400 Operations Instructions download pdf (Page 29)

Administrator’s Guide and Operating Instructions

Alarm Out – To define which Alarm Output will be triggered when

the hard disk capacity is full. NC and NO signals are available,

please refer to Alarm Out Setup. Click on the Down arrow button

to select one of the Alarm Outputs (AO 1-4).

Output – Alarm Out output state when the hard disk capacity is full.

For NC signal, it’s always

open

, for NO signal

. The Normal

State above shows whether the selected Alarm Out is NC signal or

NO signal.

Buzzer On – To activate the internal buzzer or not when the full hard

disk capacity is detected.

Log – Log to event log list or not. Please refer to Log Display for

the details.

Show Message – To display the alarm message or not when the full

hard disk is detected.

Send Mail – Check to activate the e-mail notification function. There

will be an e-mail notification sent to the defined receivers while the

hard disk capacity is less than 10%. Please refer to Chapter 6.15 for

e-mail notification setting.

Note. If the hard disk capacity reaches the end with the Auto Overwrite function

disabled while the user login in as an Operator, the system will show a message

to ask the user to login in as an Administrator or Supervisor for the further

procedures.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 66 67

No comments

EverFocus eDR400 Operations Instructions Page 29