EverFocus EPHD08 User Manual download pdf (Page 71)

Network Loss:

Figure 4-19 Alarm & Event Menu – Event – Network Loss

Log: Check box to record events in the log.

Buzzer: Check box to enable buzzer when network is lost.

Alarm Output: This will transmit a signal through the alarm output relay. It can be set to either “NONE” (not

active), “1” or “2” (active).

Output Type: Output action when alarm is triggered.

Timeout: Alarm output lasts for the set time duration.

Permanent: Alarm will be continuously active until user presses “Enter” key.

Transparent:

Alarm output remains active until event ends.

Trans+Timeout: Alarm output continues until event ends, then lasts for the set time duration.

Timeout Duration: The amount of time the buzzer sounds when DVR stops recording. Duration selectable

from 1 to 150 seconds.

NOTE: This function only checks the physical connection (link) to the network. Any network behavior

that blocks data connectivity (blocked ports, IP addressing errors, etc.) is not detected by this function.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 141 142

No comments

EverFocus EPHD08 User Manual Page 71