EverFocus ES2426-31 User Manual

ES2426-31 24-port 10/100M PoE + 2 Gigabit Copper/SFP Combo Rackmount Web Smart PoE Switch

ES2426-31 5 Flashing Data activating 26 (1~26) PoE On Port is linked to Power Device 24 (1~24) Off

ES2426-31 6 3. User Log In This part instructs user how to set up and manage the switch through t

ES2426-31 7 Main Page Figure 1-3

ES2426-31 8 4. Administrator 4.1 Authentication Configuration This page shows authentication co

ES2426-31 9 User can configure the IP settings, Subnet Mask, Gateway as below:  IP address: Manual

ES2426-31 10 4.4 Load Default Setting Clicking the Load button will make the switch being set to th

ES2426-31 11 4.5 Firmware Update Before the firmware update procedure is executed, you should enter

ES2426-31 12 5. Port Management Port Management includes Port Configuration, Port Mirroring, Band

ES2426-31 13 column as Enable or Disable.  Addr. Learning: When the Auto-Negotiation column is set

ES2426-31 14 5.3 Bandwidth Control This page allows the setting of the bandwidth for each port. The

EVERFOCUS ELECTRONICS CORPORATION ES2426-31 User’s Manual  2013 EverFocus Electronics Corp www.everfocus.com All rights reserved. No part

ES2426-31 15 Figure 3-4 The broadcast packet is only checked at the selected port and the number o

ES2426-31 16 6. VLAN Setting A Virtual LAN (VLAN) is a logical network grouping that limits the b

ES2426-31 17 the source port. This is the default setting when starting VLAN configuration. You sh

ES2426-31 18 rest of your network. On other switches you may have the chance to configure names. Th

ES2426-31 19 6.3 Multi to 1 Setting Multi to 1 VLAN is used in CPE side of Ethernet-to-the-Home a

ES2426-31 20 7. Per Port Counter 7.1 Port Counter This page provides port counter of each por

ES2426-31 21 8. QoS Setting Here you can configure QoS policy priority mode and CoS (Class of Ser

ES2426-31 22 8.2 Port, 802.1p, IP/DS based Figure 6-2

ES2426-31 23 9. Security 9.1 MAC Address Binding Figure 7-1  Port No: Displays the port number

ES2426-31 24 9.2 CP/UDP Filter Figure 7-2

ii Safety Precautions FCC Warning This Equipment has been tested and found to comply with the limits for a Class-A digital device, pursuant to Part

ES2426-31 25 10. Spanning Tree 10.1 STP Bridge Settings Figure 8-1  Bridge Priority: This par

ES2426-31 26 10.2 STP Port Settings Figure 8-2  Port No: The port ID. It cannot be changed. Agg

ES2426-31 27 10.3 Loopback Detection Settings Figure 8-3

ES2426-31 28 11. Trunking Port trunk allows multiple links to be bundled together and act as a sing

ES2426-31 29 12. Backup /Recovery This function provides the user with a method to backup/recovery

ES2426-31 30 13. Miscellaneous Miscellaneous setting is used to configure output queue aging time,

ES2426-31 31 14. Logout The administrator has write access for all parameters governing the onboar

ES2426-31 32 15. Specification Model Name ES2426-31 Standards Ethernet: IEEE 802.3 10BaseT, IEEE

ES2426-31 33 Management: Web Management, password protected access, Configuration backup/restore, T

EverFocus Electronics Corp. EverFocus Taiwan: 12F, No.79, Sec. 1, Shin-Tai Wu Road, Hsi-Chih, Taipei, Taiwan TEL: +886 2 2698 2334 FAX: +886 2 2698

iii TABLE OF CONTENTS 1. Introduction ...

iv 8. QoS Setting ... 21 8.1 Priorit

ES2426-31 1 1. Introduction 1.1 Product Overview This switch provides 24 10/100Mbps RJ-45 ports a

ES2426-31 2 MAC address filtering TCP/UDP Port filtering • STP/RSTP • Spanning Tree Protocol • B

ES2426-31 3 1.5 Performance • MAC Address: 4K • Buffer Memory: 2.75Mb • Transmission Method: Sto

ES2426-31 4 2. Hardware Description This section mainly describes the hardware of the 8 PoE por